Instructions for Use:
Start with a clean, tangle free mane and tail. It is recommended that you start at the withers and work your way up the mane. Then prepare the mane as you would with a pulling comb. Steps: 1. Back comb into the mane the holding the hair (under tension) with one hand, comb in the other and push top hairs back until the desired amount of under hairs to be removed is in the teeth of the comb. 2. At this point DO NOT PULL THE COMB DOWN; raise the hair held in your hand up into the blades so that the hair is under tension. Then press the lever down on the handle and the hair will be clipped. (For medium/thick manes go closer to the roots). 3. Comb out the tangles for the next cut. When the desired length is reached you may want to pinch or nip off ends of the hairs with your fingers to complete the look. Cleaning the comb: 1. Remove the two fixing screws and lift off the blade cover. 2. Remove the blade fixing. 3. Lift blades off the mounting pins and clean off debris. 4. Separate blades and rinse with water. 5. Dry with cloth and spray sparingly with WB40. To replace the blades: 1. Follow steps 1 & 2 under cleaning instructions. 2. Lift blades off mounting pins. 3. Insert new blades. 4. Replace blade fixing plate. 5. Replace blade cover and screws.